JK RECOVERY LOOPS

The JK Recovery Loops are engineered from 3/4” heavy duty steel and mount directly to the Chassis rail frame. Giving you secure bolt/pin connection points for any tow bar. Designed to work with a 3/4” D-rings and 7/8" Pins. These Recovery Loops are designed for 10A/X, Hard Rock Rubicon and JK Wrangler front bumpers.

INCLUDES:

2 - RECOVERY LOOPS

HARDWARE MOUNTING KIT

IMPORTANT: MANDATORY FOR FLAT TOWING

IF YOU ARE FLAT TOWING YOUR JEEP BEHIND A MOTORHOME or RV the Towing Tie Rod is MANDATORY FOR SAFETY. 
The Maximus-3 Towing Tie Rod (PN # JL1020TR) triangulates your tow bar at the adapters connections preventing the tow-bar arms from spreading outwards in the event of surge break delay or malfunction. The Tie Rod will keep your towing load forces straight into the setup to prevent any side stress loads especially during braking and hard turns. 

***WARNING***

Failure to install properly can results in non-warranty damage, property damage, personal injury or death. When flat towing always make sure you regularly check your equipment & pins to ensure all products are secure. Maximus-3 is not responsible for property damage, personal injury or death.


Please Note:

This product will require cutting your skid plate as well as your bumper.  

• MATERIAL: 3/4” Thick Steel – Flat Laser Welded
• SURFACE FINISH: Durable Red Gloss or BlackTextured Powder Coat
• ADDED WEIGHT: 8 Lb. 8.7oz. (approx.)
• MADE IN: USA

Estimated Installation Time: 5 Hours

Installation Difficulty Level: Advanced

Installation Guides: PDF

2007 - 2018 JK WRANGLER

10A/X , Hard Rock and JK bumpers only.